Where is fuse box 1987 Jeep Wrangler - answers wwwers››Jeep›Jeep Wrangler›Jeep Wrangler SaharaAnswer The fuse box on the 87 Wrangler is located on the driver side under the dash WAY UP top by the windshield. I need a fuse diagram for a 1987 jeep wrangler yj - Fixya wwwa››Jeep›Wrangler›1987 Jeep WranglerI need a fuse diagram for a 1987 jeep wrangler yj. Posted by Martha Williams on Oct 04, 2011. SOURCE: Jeep wrangler Fuse box. You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US. Here's a link to this great service Good luck!I'm assuming you mean the box under your dash if this isn't what you want let me know2i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck0You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.0Read someone documents about this model: 1991-1995 Jeep Wrangler YJ Good luck!!!0caster is adjusted at the rear of the lower control arms. Camber is fixed and cannot be adjusted by normal means (though special off-set ball joints are available to do that) Toe in is adjusted by turning the sleeves in or out on the tie rod ends. None of this should be done at home though crude adjustments can be made in order to get the front end reasonably straight. Adjustments are made on an alignment machine that allows precise adjustments to all you mentioned as well as front/rear tracking.0