2013 CHEVY CRUZE FUEL FILTER
SOLVED: Were is the fuel filter located at on a 2013 chevy
wwwa›Forum›Cars & TrucksWere is the fuel filter located at on a 2013 chevy cruze gas 1.4 lt - Cars & Trucks question. Search Fixya Were is the fuel filter located at on a 2013 chevy cruze gas 1.4 lt. Posted by Johnny murphy on Nov 02, 2017. Changing the fuel filter on a 1998 Chevrolet Venture minivan,Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US. Here's a link to this great service Good luck!there ain,t no regular fuel filter. there,s a screen attached to the module/pump.0Its Underneath The Car By The Right Rear Tire.0LOCATION OF FILTER IS DRIVER SIDE FRAME RAIL ABOUT AT DRIVER DOOR HARD TO SEE BUT FALLOW FUEL LINE ITS THERE. hOPE THIS HELPS PLEASE RATE ME !! THANK YOU AND GOOD LUCK TOOLS Are Simple and inexpensive local Parts Store like AutoZone will Have it FUEL FILTER REPLACEMENT TOOLS REQUIRED J-46363 Fuel Line Release Tool REMOVAL PROCEDURE Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
Raise and suitably support the vehicle. Refer to Vehicle Lifting .
Remove the fuel composition sensor bracket nutssition the fuel composition sensor/bracket off to the side
Using a flare nut wrench and backup wrench disconnect the fuel line fitting from the fuel filter.
Pull the quick connect fitting back until the internal retainers hit the filter stop. Twist one end of J-46363 and insert it between the fitting and the filter. Twist the opposite end of J-46363 and insert it between the fitting and filter. Once J-46363 is inserted, ensure that J-46363 is parallel to the filter and fitting.
While holding the filter, push the fitting towards the filter in order to disconnect the quick connect fitting.
Remove the fitting from the filter.
Remove J-46363 from the filter.
Remove the fuel filter from the bracket. INSTALLATION PROCEDURE Install the NEW fuel filter to the brackete holding the filter, push the fitting towards the filter in order to connect the quick connect fitting Using a flare nut wrench and backup wrench connect the fuel line fitting to the fuel filter.
Position the fuel composition sensor/bracket into place. NOTE: Refer to Fastener Notice in Service Precautions.
Install the fuel composition sensor bracket nuts. Tighten the nuts to 17 N.m (13 lb ft) .
Lower the vehicle.0Driver side go under truck around driver's door mounted on inner side of fram rail.0underneath car driver side0Fuel filter just part of the fuel pump located inside the fuel tank. Btw, I’m available to help over the phone in case u need at https://www/expert/don_e04c7d10037aa2ce0It's built in to the fuel pump assembly located in the fuel tank.0Where's the fuel filter on 2013 chevy spark - FixyaWhere is the location of the fuel filter on Chevrolet CruzeSee more results
Fuel Filter Location? - Maintenance - Chevrolet Cruze Forum
wwwroletcruzeforum››MaintenanceFuel Filter Location? - posted in Maintenance: Does anyone know where the fuel filter is located on a 2014 Cruze 1.4 U.S. spec.? I cannot even find an application for the replacement filter Changing the engine oil in 2010 model - Cruze 2 DieselJun 19, 2013Under the hood Air Filter - Maintenance - Chevrolet CruzeApr 28, 2012Fuel Injection service??? - Maintenance - Chevrolet Cruze Diesel particle filter - Welcome - Chevrolet Cruze Forum See more results