ATWOOD RV FURNACE THERMOSTAT WIRING
How to wire an Atwood gas furnace model 8535-iv dclp?
The furnace will only come on when the t-stat closes and the two blue wires come together, if the wiring from the t-stat to the heater is good and not shorted together, it is the t-stat or a problem in the furnace itself, disconnect the t-stat wires at the t-stat and the heated and ohm them out for continuity.Here is the service manual on the heater, it shows the wiring and how to wire it, what problem are you having?What t-stat do you have?Coleman-correct? Coleman uses 12 volts from the furnace to power the thermostat. the furnace should be wired-red is 12 volt positive, yellow is gr..Then the thermostat is wired correctly, if no wiring on the t-stat has been changed, the t-stat is bad and needs replaced.You installed new wires from the heater to the t-stat and from the t-stat to the a/c? The only thing that can cause any problem with the heater fun..
A/C - furnace wiring - Technical Tips and Tricks
Aug 04, 2015My Atwood furnace also worked through the thermostat. After wiring up the a/c and new thermostat, which was all labeled and a no-brainer, I had 2 white wires and 2 orange wires left over. These are heavy wires, not thermostat wires.
Related searches for atwood rv furnace thermostat wiring
atwood rv furnace thermostat instructionsrv furnace thermostat wiringatwood furnace thermostat manualatwood furnace thermostat replacementatwood rv furnace parts diagramatwood rv thermostat manualatwood rv heaters furnacesatwood rv thermostat replacement