BRYANT GAS FURNACE THERMOSTAT WIRING

how do you wire a honeywell thermostat to a bryant furnace
Jan 24, 2013How do you wire a honeywell thermostat to a furnace - Answered by a verified HVAC Technician Have a white-rogers LR 27935 thermostat on a Bryant gas furnace and a (brand?) AC compressor. Wires on thermostat are Blue wire to the Y, (White) D(Red), on the old Bryant Evolution Thermostat, the wiring matches the furHello, Do you have thermostat wires run already and just need to connect them?Ok do you just have a Bryant standard furnace and central AC outside with no heat pump?Ok if there is no AC then the wiring is very straightforward. Red wire to RH terminal on furance board and RH terminal on thermostat White wire to..OK then Red and White are what I listed.. Blue will just go to the G terminals on both furance and thermostat. The blue will be your fan conn..Yes there should be one on the furnace and the thermostat. there is not one list me the terminals on each unit.Ok normally the BLUE would go to the Y terminal, which is your Central Air conditioner terminal. you do not have this..I would go to the furn..No problem sounds good, just some of them the Blue was on the C terminal so you just have to be sure. All I ask is that you rate my assistance tha..Yes you may have blown the low voltage fuse on the board inside the furnace.No just replace the fuse on the board. There usually is a slot style fuse right on the board, same as a automotive fuse 3-5amp. See if it is blown..Ok if you are down at the furnace, Jump R to W on the board and see if the unit comes on. Make sure you have the safety panel switch depressed as n..
Product manuals - Product Documents | Bryant
Gas or oil furnace. Remove the front door and look inside the unit. You should see the model number printed on rating-plate or decal. Ventilators, evaporator coils and fan coils. You should be able to see the model number on a rating-plate or decal right on the front of a ventilator or an evaporator coil and on the side if you have a fan coil.