DIAGRAM OF WELDING DIRECTION OF TRAVEL
Arc Welding Positions - tpub
The electrode angle consists of two positions: work angle and travel angle. Work angle is the angle from the horizontal measured at right angles to the direction of welding (fig, 7-15). Travel angle is the angle in the direction of welding and may vary from 5 to 30 degrees, depending on the welder's choice and conditions (fig. 7-16).
Arc Welding aka Shielded metal arc Welding
When welding a T or inside corner joint with one piece of the base metal in a near vertical position, and one in a near horizontal position, the arc welding electrode is inclined 20 deg in the direction of travel. The arc welding electrode is also positioned at about 45 deg. angle to the horizontal piece of metal. The motion is usually some type of weave with the forward motion taking place on the vertical piece.
Welding Chapter 6 Flashcards | Quizlet
Start studying Welding Chapter 6. Learn vocabulary, terms, and more with flashcards, games, and other study tools.
Five Steps to Improving Your Stick Welding Technique
Angle of travel: Stick welding in the flat, horizontal and overhead positions uses a drag or backhand welding technique. Hold the electrode perpendicular to the joint, and then tilt the top in the direction of travel approximately 5 to 15 degrees.
Welding - Chapters 1-6 - First Exam Flashcards | Quizlet
Welding - Chapters 1-6 - First Exam. when the work is made negative and the electrode is positive this is known as direct-current-electrode-positive, or reverse polarity. the positive ions impinge on the work piece, breaking up any oxide films and giving deeper penetration. however, metal deposition is lower.