DRAW STANDARD HOLE CALLOUTS
2020 SOLIDWORKS Help - Adding Hole Callouts in a Drawing
If you attach a hole callout to a tapped hole in ANSI inch standard and the current drawing units are millimeters, the drill diameter and hole depths are reported in mm but the thread description retains the ANSI inch size designation. You might want to replace the thread description with other variables from the Callout Variables dialog box.[PDF]
Engineering Design Representation - UFL MAE
Because of this, the thru hole requires no specification of depth in the note. The word “THRU” should not be included with the note. If no depth is specified, a hole is by default a thru feature. This is demonstrated in the notes for the countersunk and counterbored holes shown in Figures 8 and 9.
Related searches for draw standard hole callouts
hole callouts on drawingsthreaded hole callout standardsengineering drawing hole callouthole callout formathole callout symbolstapped hole drawing callouthow to read hole calloutshole callout solidworks drawing