NETWORK CABLE WIRING
conceptdrawImage: conceptdrawAn Ethernet cableis used to manage Local Area Networks (LANs). An Ethernet cable is long and contain a lot of wires. Wiring this type of computer cable involves collecting materials,sorting out the wires and connecting the system to the Ethernet jack.
How do I Wire an Ethernet Cable? (with pictures) - wiseGEEK
Is this answer helpful?Thanks!Give more feedbackThanks!How can it be improved?How can the answer be improved?Tell us howPeople also askHow to wire an Ethernet cable?How to wire an Ethernet cable?How to wire fixed Ethernet Cables: Run the full length of ethernet cable in place,from endpoint to endpoint,making sure to leave excess.At one end,cut the wire to length leaving enough length to work,but not too much excess.Strip off about 2 inches of the ethernet cable sheath.Align each of the colored wires according to the layout of..See More..How to wire Ethernet Cables - ertyuSee all results for this questionWhat is the best Ethernet cable?What is the best Ethernet cable?Best Ethernet Cable for Gaming. Mediabridgehas made this fastest Cat5e Ethernet cablewhich is 50-foot long and comes with an RJ45 connector. The RJ45 connector perfectly fits in the Cat5e and Cat6 ports.Best Ethernet Cable for Gaming Reviews of 2017 | TopSee all results for this questionWhat is a network cable?What is a network cable?Broadly speaking,a networkcableis a type of cablewiring used in telecommunications that relays data from individual computers to a larger networkmainframe. Sometimes these cablesare external,and can be used to do things like plug computers into Internet modems or grounded ports.What is Network Cable? (with pictures) - wiseGEEKSee all results for this questionHow to make your own Ethernet cable?How to make your own Ethernet cable? Strip the cable jacket about 1.5 inch down from the end.Spread the four pairs of twisted wire apart.Untwist the wire pairs and neatly align them in the T568B orientation.Cut the wires as straight as possible, about 0.5 inch above the end of the jacket.Carefully insert the wires all the way into the modular connector, making sure that each..See More..How to make your own Ethernet cable - CNETSee all results for this question
How to Make a Network Cable: 11 Steps (with Pictures
Oct 23, 2018How to Make a Network Cable - Steps Unroll the required length of network cable and add a little extra wire, just in case. Carefully remove the outer jacket of the cable. Inspect the newly revealed wires for any cuts or scrapes that expose the copper wire inside. Untwist the pairs so they willViews: 1
How To Make An Ethernet Cable - Simple Instructions
CROSSOVER CABLES - The purpose of a Crossover Ethernet cable is to directly connect one computer to another computer (or device) without going through a router, switch or hub. Here's how to make a standard cable: Cut into the plastic sheath about 1 inch (2.5 cm) from the end of the cut cable.