RADIO WIRE HARNESS GAUGE

Gauge wire used for stock radio? | Tacoma World
wwwmaworld››1st Gen. Tacomas (1995-2004)Oct 27, 2011The Metra harness plugs into the factory plugs and has bare wires on the other end. The Pioneer has a harness that plugs into the back of the radio and has bare wires on the other end. It's those bare wires that need to be matched up and I will solder/heatshrink them.
What Gauge/AWG wire for Automotive wire harness use
answerso››Maintenance & Repairs›NextJun 21, 2012The problem is the wire harness connectors (driver door) and (passenger door) doesn't connect to the main wiring harness of the vehicle. In other words my car's trim was never intended to have power windows so the main wiring harness don't have those "ready" or "standby" connectors just in case you plan to convert to oem power windows in the future.Status: ResolvedAnswers: 4The general rule for wiring size is to use the largest wire that will fit. The larger the wire the less resistance and the cooler it operates. Not being familiar with your exact model car it sounds like you should probably use the same size fuses as Honda installed originally. If the donor car used 20 amp fuses then use 20 amp ones in line and you should be OK. Place them as close to the window motor as possible so that if the wires get pinched or something then the fuses will blow for any reason, including the motor itself shorting.Best answer · 0If is a 20 amps fuse, you'll need a 12 awg wire and only one fuse also 20 amps.0No, he won't would desire to take the harness out; he can verify it by using using an ohmmeter and wiggling the harness jointly as watching the meter examining. The coil %. is powered up by using one twine, so if the feed ability became intermittent, the full factor might lose ability, no longer one coil. that is lots greater probable you have an issue with the coil itself, or perhaps the module that runs the coil %. i does no longer believe your modern tech, try for yet another diagnosis at a diverse save. solid luck!0