WIRING HARNESS FOR A PLASMACAM
Model DHC /510 - PlasmaCAM Cutting Systems
www.PlasmaCAM Model DHC 2/510. Motor Testing Procedure & Wiring Harness Diagrams PO Box 19818 •••• 5112 Graneros Rd. •••• Colorado City, CO 81019 ••• (719) 676 -2701 •••• fax (719) 676 -2711. Preparing to test the motors. Before doing these tests thoroughly inspect the harness for any signs of a short circuit and frayed or bare wires.
PlasmaCAM - Computer-controlled XY table w/ height control
Hand Plasma Torch The PlasmaCAM cutting table fits almost any hand plasma torch. The torch is fairly easy to remove and replace, in case you need to use it for other types of cutting. To put your torch under the control of the machine, you can wire its trigger switch to a relay on the machine.
Cable harness - Wikipedia
A cable harness, also known as a wire harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. The cables are bound together by a durable material such as rubber, vinyl, electrical tape, conduit, a weave of extruded string, or a combination thereof.