How do you hook up a tachometer to a Chevy 350 with HEI How do you hook up the tachometer to the distributor on a Chevy 350? If it is the HEI there is a terminal toward the bottom marked tach this is where the trigger wire will go (usually green). I have a 350 Chevy with HEI distributor and. It just stopped Sep 28, 2015I have a 350 Chevy with HEI distributor and carburetor. It just stopped in traffic and would not restart. I had been planning to replace the distributor so I went ahead and did that. I have 12 volts going to the distributor and verified that I have a good ground between the engine and chassis. The timing is right.Hello! If you have 12 volts at the terminal in an HEI and no spark either the distributor is not turning (remove the cap and crank to see) or that..Right the power for the distributor is good then when it turns it sends out a spark. If theres power to the distributor and no spark its bad.Yes, but careful that distributor makes a punch. I would lay the plug in the wire on the intake and just watch it.Did the new distributor come with a new ignition module? The module is a chip inside the distributor with two wire connections on it.Hello! That module is bad or the pickup coil is bad. Reason why is the coil gets hot meaning its powered up. I highly doubt the auto parts store ca..
Related with with a chevy 350 hei distributor tach wiring